Quasiparticle cooling of a single-Cooper-pair-transistor

A superconducting tunnel junction is used to directly extract quasiparticles from one of the leads of a single-Cooper-pair-transistor. The consequent reduction in quasiparticle density causes a lower rate of quasiparticle tunneling onto the device. This rate is directly measured by radio-frequency reflectometry. Local cooling may be of direct benefit in reducing the effect of quasiparticles on coherent superconducting nanostructures.Comment: 4 figure

Low energy activation analysis for geochemical exploration

Low energy activation analysis for geochemical exploratio

Characterization of low intensity X-ray imaging devices (Lixiscope)

Radioisotopic sources were used to excite the LIXISCOPE in preliminary experimental attempts to evaluate the usefulness of this instrument for industrial and medical applications. The characteristics of the LIXISCOPE when excited by x-ray produced by conventional electrically powered x-ray generators were studied. The optimum x-ray spectrum was determined and the mode of operation of the generator, which yields satisfactory LIXISCOPE images of medical and industrial specimens was investigated

Evaluation of the advance/anticipatory care planning (ACP) facilitators training programme

This report presents an overview of the findings of the three phases of the study and assesses the degree to which the Facilitator Training Programme and Resource Pack have prepared the cohort of facilitators with the knowledge, skills and tools to deliver training initiatives in ACP to address local and regional needs

Nanoindentation of bone: Comparison of specimens tested in liquid and embedded in polymethylmethacrylate

Elastic modulus of bone was investigated by nanoindentation using common methods of sample preparation, data collection, and analysis, and compared to dynamic mechanical analysis (DMA: three-point bending) for the same samples. Nanoindentation (Berkovich, 5 μm and 21 μm radii spherical indenters) and DMA were performed on eight wet and dehydrated (100% ethanol), machined equine cortical bone beams. Samples were embedded in polymethylmethacrylate (PMMA) and mechanical tests repeated. Indentation direction was transverse to the bone long axis while DMA tested longitudinally, giving approximately 12% greater modulus in DMA. For wet samples, nanoindentation with spherical indenters revealed a low modulus surface layer. Estimates of the volume of material contributing to elastic modulus measurement showed that the surface layer influences the measured modulus at low loads. Consistent results were obtained for embedded tissue regardless of indenter geometry, provided appropriate methods and analysis were used. Modulus increased for nanoindentation (21 μm radius indenter) from 11.7 GPa ± 1.7 to 15.0 GPa ± 2.2 to 19.4 GPa ± 2.1, for wet, dehydrated in ethanol, and embedded conditions, respectively. The large increases in elastic modulus caused by replacing water with ethanol and ethanol with PMMA demonstrate that the role of water in fine pore space and its interaction with collagen strongly influence the mechanical behavior of the tissue

Development of hazard analysis and critical control points (HACCP) procedures to control organic chemical hazards in the agricultural production of raw food commodities

Hazard Analysis by Critical Control Points (HACCP) is a systematic approach to the identification, assessment and control of hazards in the food chain. Effective HACCP requires the consideration of all possible hazards, i.e., chemical, microbiological and physical. However, current procedures focus primarily upon microbiological and physical hazards, and, to date, chemical aspects of HACCP have received relatively little attention. Consequently, this report discusses the application of HACCP to organic chemical contaminants and the particular problems that are likely to encounter within the agricultural sector. It also presents generic templates for the development of organic chemical contaminant HACCP procedures for selected raw food commodities, i.e., cereal crops, raw meats and milk

Constructing Wildebeest Density Distributions by Spatio-temporal Smoothing of Ordinal Categorical Data Using GAMs

Spatio-temporal smoothing of large ecological datasets describing species distributions can be made challenging by high computational costs and deficiencies in the available data. We present an application of a GAM-based smoothing method to a large ordinal categorical dataset on the distribution of wildebeest in the Serengeti ecosystem

A general analytical model of adaptive wormhole routing in k-ary n-cubes

Several analytical models of fully adaptive routing have recently been proposed for k-ary n-cubes and hypercube networks under the uniform traffic pattern. Although,hypercube is a special case of k-ary n-cubes topology, the modeling approach for hypercube is more accurate than karyn-cubes due to its simpler structure. This paper proposes a general analytical model to predict message latency in wormhole-routed k-ary n-cubes with fully adaptive routing that uses a similar modeling approach to hypercube. The analysis focuses Duato's fully adaptive routing algorithm [12], which is widely accepted as the most general algorithm for achieving adaptivity in wormhole-routed networks while allowing for an efficient router implementation. The proposed model is general enough that it can be used for hypercube and other fully adaptive routing algorithms